Veto Pro Pac VPP-CP4 4 Pocket Grubber Pouch

The CP4 Grubber is a multi-purpose pouch that can hold a variety of small tools and accessories for service, repair or installation jobs as well as a perfect weekend travel pouch for small items.For weekend/personal use, the CP4 is a perfect pouch to carry many items, and you can clip keychains and other items to the D-rings…\r\nSpecifications\r\n\r\nHeight (BH): 7in (18cm)\r\nWidth (W): 11in (28cm)\r\nDepth (D): 4in (10cm)\r\nWeight: 1lb (.5kg)\r\nMax Payload: 12lbs (5.5kg)\r\nInternal Volume: 164in3 (2.5L)\r\n\r\nCapacity\r\n\r\nTool Pockets: 4 pockets of various sizes\r\nSmall Meter Storage Pocket\r\nD-Rings: 1 large 1.5in D-Ring\r\nCable and Accessory Pockets\r\n\r\nBuild\r\n\r\nWeatherproof, rubberized bottom\r\nWeatherproof Body Fabric: 600 PVC Impregnated Denier Nylon\r\nWeatherproof Inside Pocket Fabric: 600 PVC Impregnated Denier Nylon\r\n1/4in Piping for Gripping with Fingers\r\nInside Mesh Pocket\r\nZippers: Double Stitched, Heavy Duty Plastic Coil Zippers with Oversized Zipper Tabs\r\nD-Ring: Powder Coated Steel\r\nStitching: Industrial Strength Double Nylon Stitching\r\nWarranty: 5 Years (see Veto warranty terms and conditions)\r\n\r\nKeep the Zippers Clean and Lubricated\r\nOver time, dirt and grit will clog the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.\r\nProtect the Zippers From Sharp Objects and/or Excessive Heat\r\nAny sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.\r\nDon’t Overstuff the Bag\r\nOverstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!